Version
2.1.22
Hardware / Firmware
GRBL 1.1
What happened
Hello,
I’ve noticed some interaction recently between keyboard commands that I’ve setup in Keymaps and my Macros list. Specifically when using Control-Shift F2 and/or F3 and Control F2 and/or F3. When using these I see the Macros in my list duplicating themselves. If I keep tapping the command sequences I can eventually get it back to normal. This has been happening ever since versions 2.1.21 and 2.1.22 were installed. I think 2.1.20 was the last version where it was not affected?
This is occurring on systems with Win7, Win10 or Win11. I’ve tried deleting the Macros Tab in the program then choosing to add Macros back in from the Windows pulldown but it doesn’t seem to have any effect on rectifying the problem. I've attached a copy of the log file also.
Thanks for looking!
How to reproduce
No response
Operating System
Win7, Win10 and Win11
Anything else
messages.log
Version
2.1.22
Hardware / Firmware
GRBL 1.1
What happened
Hello,
I’ve noticed some interaction recently between keyboard commands that I’ve setup in Keymaps and my Macros list. Specifically when using Control-Shift F2 and/or F3 and Control F2 and/or F3. When using these I see the Macros in my list duplicating themselves. If I keep tapping the command sequences I can eventually get it back to normal. This has been happening ever since versions 2.1.21 and 2.1.22 were installed. I think 2.1.20 was the last version where it was not affected?
This is occurring on systems with Win7, Win10 or Win11. I’ve tried deleting the Macros Tab in the program then choosing to add Macros back in from the Windows pulldown but it doesn’t seem to have any effect on rectifying the problem. I've attached a copy of the log file also.
Thanks for looking!
How to reproduce
No response
Operating System
Win7, Win10 and Win11
Anything else
messages.log