Forgive me if this is stupid :)
I was not able to insert M3 screws into most of the holes. I checked the CAD and noticed that some of the holes have a diameter of 2.6 mm (for example, the pair holding the motor driver extension board). Should I tap the hole, or is it a problem of my 3D printer's percision? I am using a Bamboo Lab A1 mini with PLA.
Thank you sooo much for the time and efforts
Forgive me if this is stupid :)
I was not able to insert M3 screws into most of the holes. I checked the CAD and noticed that some of the holes have a diameter of 2.6 mm (for example, the pair holding the motor driver extension board). Should I tap the hole, or is it a problem of my 3D printer's percision? I am using a Bamboo Lab A1 mini with PLA.
Thank you sooo much for the time and efforts