Category
Other
Hardware
Other
Is this bug report about any UI component firmware like InkHUD or Meshtatic UI (MUI)?
Firmware Version
Tested on 2.7.15 and 2.7.17
Description
After flashing the new firmware (2.7.15) the heltec meshsolar (wich is the base for the heltec meshtower) it constantly reboots every 8-10 minutes in every cenario.
It doesnt matter if its powered by solar, USB PD or just running standalone in different temperature ranges (-10C to 25C).
It only gets an uptime of about 9 minutes before it reboots.
There is a topic on the heltec forum (http://community.heltec.cn/t/heltec-meshtower-resets-its-configuration-itself/20570/36) wich as it seems, they fixed it on meshcore wich experienced the same issue.
I know that the meshsolar is only community supported and im sorry if this is misplaced here, but i dont know where to put it else.
Relevant log output
Category
Other
Hardware
Other
Is this bug report about any UI component firmware like InkHUD or Meshtatic UI (MUI)?
Firmware Version
Tested on 2.7.15 and 2.7.17
Description
After flashing the new firmware (2.7.15) the heltec meshsolar (wich is the base for the heltec meshtower) it constantly reboots every 8-10 minutes in every cenario.
It doesnt matter if its powered by solar, USB PD or just running standalone in different temperature ranges (-10C to 25C).
It only gets an uptime of about 9 minutes before it reboots.
There is a topic on the heltec forum (http://community.heltec.cn/t/heltec-meshtower-resets-its-configuration-itself/20570/36) wich as it seems, they fixed it on meshcore wich experienced the same issue.
I know that the meshsolar is only community supported and im sorry if this is misplaced here, but i dont know where to put it else.
Relevant log output