Bus timing values when pressing reset for 5 sec.

[W0RMinator]

I read that the new v0.22 releases have 3 different sets bus timing values when pressing reset for 5 seconds. Will someone please let me know what those 3 sets of values are?
Thanks

[frntc]

(7, 11), (1, 12), (11, 15), default is (3,12) <- this you get when doing a "factory reset"

[modeler]

(7, 11), (1, 12), (11, 15), default is (3,12) <- this you get when doing a "factory reset"

These are in the order READBUS, PHI2 is that right? This is the order they are set in the .UF2 file at $2020, but SKpicopatch takes them as arguments the other way around.

Also curious why the second pair of values has READBUS set to 1, where the previous documentation states this should be in the range 3-20 ?

[frntc]

yes, readbus & phi2.

well, the 3 seemed reasonable at that time, but I did some measurements (using the SKpico as logic analyzer :-)) which showed that (1, 12) is fine as well.

[modeler]

Thanks for confirming, I like this feature a lot. If there is one nit-pick I have with SKP (and it is a very minor one) it's the bus timing issue with some boards, and this makes it a lot easier to deal with.

[W0RMinator]

Thank you. I like that you added this to the firmware!